Laser Beam Energy Intensity Parameters
Power or energy is known from the following:
- Power or energy of the beam
- Type of wavelength (CW, pulsed)
The area of the beam is the second component. As the beams diameter becomes larger, it is important to know at what distance you are computing the area (or assume the worst-case). For example, when purchasing a laser barrier, it is helpful to know how much protection is needed at a given point in the room.
Along with knowing the area, the intensity can vary at different points within the beam (or if a p-hat distribution, the intensity will be constant). This is important when calculating energy intensity as the area of the beam does not (if a gaussian distribution) have a constant intensity in the area of the beam.
To do so, the following parameters can be helpful:
- Shape of the beam
- Angle of divergence
- Distribution of the beam (Gaussian vs P-hat)
- Whether or not the beam is focused with a lens or not
Ultimately, this article is simply trying to demonstrate what a Laser Safety Officer calculates when making laser safety calculations surrounding the beam.
The shape of the beam is part of the area calculation in the energy density equation. Below, we have depicted three different shapes and resultantly with a little geometry you will be able to see how the calculation of the area of the beam may change.
The angle of divergence for the beam is also helpful if the laser is traveling over a long distance. The image below illustrates how the diameter becomes larger over a greater distance. The rate at which this is happening is the angle of divergence.
Another factor in calculation the energy density is understanding how the beams energy intensity is distributed. Most laser beams have a Gaussian distribution while others have what is known as a "p-hat" distribution - an equal level of intensity across the entire beam. The distribution has can have a significant impact when making laser safety calculations.
Please note that the image depicted below is 2-dimensional, while the distributions in reality are 3-dimensional space that take on the shape of the beam - in this case a circle. We've included an image of the surface area of a circular beam and the corresponding energy intensity of each distribution.
Related Articles
Buyers Guide | What is OD (Optical Density) Laser Safety?
Optical Density (OD) in laser safety is the amount of light attenuated[i] by the lens of the particular wavelength that is being measured. The required OD determined by the World Laser Safety in the USA found in ANSI Z136.1 are dependent upon several ...Buyers Guide | How to Choose Your Laser Safety Glasses
To understand what laser safety glasses to purchase, the most important parameter is your laser's wavelength (or wavelength range). Often, a laser has two wavelengths affiliated with it: The aiming beam wavelength - the aiming beam is typically "eye ...Maximum Permissible Exposure (MPE) in Laser Safety
Maximum Permissible Exposure (MPE) can be thought of as a person’s laser safety speed limit . It is the maximum level of laser radiation the human eye or skin can be exposed to without hazardous effects or biological changes. MPE is dependent on the ...Class 4 Laser Safety: Hazards, Precautions, and Best Practices
Lasers are categorized based on their potential hazards. The classification ranges from Class 1 to Class 4 (highly hazardous). The Laser Institute of America (the secretariat of the ANSI Z136 standards) provides laser classifications here. Key ...Laser Safety Standards: ANSI vs CE - What's the Difference?
In Laser Safety, there are two primary standards (or norms) that are followed, the American National Standards Institute (ANSI) and European Norms (EN), adopted by EU member countries. It should be noted OSHA also plays a role (we comply with both ...